EN
Diagram
1
Handlebar
Bell
Brake Lever
Headlight
Quick-release Lever
Folding Mechanism
Safety Lock
Reflector
Front Fork
Front Fender
Hub Motor
01
Dashboard & Power Button
Electronic Throttle
Dashboard & Power Button
Snap Hook
Stem
Footboard
Disc Brake
Power Button:
Buckle
to turn on/off the headlight and the rear light, and press twice to switch between the speed modes.
Speedometer:
Rear Fender
Walk Mode:
F25E II: The headlight and rear light keep flashing and can't be turned off.
Rear Light
F40D II: The headlight and rear light are always on and can't be turned off.
& Reflector
* How to enable in the Segway-Ninebot app: Tap the sidebar menu > Settings > Walk Mode.
Insurance
Speed Mode:
Plate Area
Reflector
Error Notification:
Temperature Warning:
Battery Compartment
* At this point, the vehicle cannot accelerate normally and may not be charged. Do not use until the temperature has reverted to the
normal range.
Kickstand
Bluetooth:
Battery Level:
Charge Port
* The battery power is very low when the first battery bar is red. Please charge your KickScooter immediately.
Speedometer
Bluetooth
Headlight
Temperature Warning
Press the button to turn on; press and hold the button for 3 seconds to turn off. When the KickScooter is on, press the button
It displays the current speed of the scooter, as well as error codes.
Max. speed is 5 km/h (3.1 mph).
There are three modes available. The top speed is as follows:
Model
F25E II
Mode
ECO (Energy-saving mode)
15 km/h (9.3 mph)
D (Standard mode)
25 km/h (15.5 mph)
S (Sport mode)
25 km/h (15.5 mph)
It indicates that the scooter has detected an error.
It indicates that the battery temperature has reached 55°C (131°F) or is below 0°C (32°F).
It indicates that the scooter has been successfully connected to the mobile device.
The total battery level equals 5 bars.
Speed Mode
Walk Mode
Error Notification
Battery Level
Power Button
F40D II
15 km/h (9.3 mph)
20 km/h (12.4 mph)
20 km/h (12.4 mph)
02