Installation; Install The Hood - universalblue UBCA2008-21 Manual De Instrucciones

3. INSTALLATION

INSTALL THE DUCKWORK
Caution: To reduce the risk of
tire, metal ductwork is preferred.
Decide where the ductwork
will run between the hood and
the outside.
A straight, short duct run will
allow the hood to perform
most efficiently.
Long duct runs, elbows, and
transitions will reduce the
performance of the hood. Use
as few of them as possible. Larger ducting may be required for
best performance with longer duct runs.
The air must not be discharge into a flue that is used for
exhausting fumes from appliances burning gas or other fuels.
Regulations concerning the discharge of air have to be
fulfilled.
lnstall wall cap. Connect round metal duct to cap and work
back towards hood location. Use duct tape to seal the joints
between ductwork sections.

INSTALL THE HOOD

Note 1: On stainless steel hoods, carefully
remove the plastic protective
film from all exterior surfaces of the
hood and chimney prior to final installation.
Note 2: At least two people will be required
to mount the hood.
23