Electrical Installation - universalblue UBCA2008-21 Manual De Instrucciones

ELECTRICAL INSTALLATION

Electrical wiring must be done by a qualified person(s) in
accordance with all applicable cedes and standards. This range
hood must be properly grounded. Turn off electrical power at
service entrance before wiring.
lf the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
INSTALL
 The manufacturer will not be held liable for any damages
resulting from incorrect or improper installation.
 Please read this instruction manual before installing and using
this range hood. Please keep this instruction manual in a
safe place for future reference.
 Only a qualified and trained service technician can undertake
the work of installation and servicing.
 Check that the main voltage corresponds to the one
indicated on the rating plate fixed inside the hood.
 lf the hood is used in conjunction with non-electrical appliances
(e. g. gas burning appliances),a sufficient degree of ventilation
must be guaranteed in the room in order to prevent the
backflow of exhaust gas. The kitchen must have an opening
directly with the open air in order to guarantee the entry of clean
air.
 The minimum distance is 750mm from the range hood toa gas
hob, and is 650mm to an electric hob. lf the installation
instructions for gas hobs specify a greater distance, this must
be taken into account.
27