Recommended Tools (Not Included); Assembly - Kreg PRS1000 Manual Del Propietário

Pre-Assembly (continued)

Recommended Tools (Not Included)

■
Kreg Flush-Trim Bit - 1/4" Shank (PRS250)
with dual bearings for trim routers that can
handle up to 1½" of material
■
Kreg Flush-Trim Bit - 1/2" Shank (PRS500)
with dual bearings for full-sized routers and
router tables that can handle up to 2" of
material

Assembly

1
Profile Templates
There are two parts bags that contain the profile templates.
a. To store the profile templates (E,F), snap the templates into the profile case (D).
b. To use a profile template (E,F), snap the desired profile into the posts (1) on the underside of
the Base Plate (A).
Optional: The profile case (D) may be installed for permanent placement
on the Kreg Multi-Purpose Shop Stand (KRS1035), [part of the Kreg
Precision Router Table System (PRS1045)]. The hole alignment on the shop
stand legs mirrors the keyholes on the profile case (D). (Recommended
hardware are two 10-24 machine screws with nuts. Not included.)
4
D
1
■
Kreg Precision Router Table System
(PRS1045)
■
Kreg Precision Benchtop Router Table
(PRS2100)
A