Common Problems, Possible Causes And Solutions; Accessories - Swissmex 319315 Manual De Operador

Línea industrial aplicadores para la construcción
Ocultar thumbs Ver también para 319315:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.
COMMON PROBLEMS, POSSIBLE CAUSES & SOLUTIONS
PROBLEM
The piston does not slide easily and there is noise
between the pump tube and the piston.
The pump system leaks.
Shut-off leaks after releasing the handle.
The sprayer is pressurized but there is no flow when
pressing the shut-off handle.
Although the sprayer is being pumped vigorously it does
not build pressure.
7.

ACCESSORIES

SCREEN SHIELDS
E1000219099
E1000219110
E1000219117
NOTE:
These accesories are not special for the construction line. For more info. please contact your sales rep.
Or :
40 cm
40 cm translucent
22 cm ( 3/8")
E1000080034 Complete strap
E1000120334 Economic strap
E1000501034 Economic strap
with shoulder pad
E1000501134 Complete strap
with shoulder pads
E1000501135 10 traps kit
www.swissmex.com
Compression sprayer
CAUSE
There is no lubrication between the pump
tube and the piston sleeve.
The antenna does not seal correctly in
the seat of the pump tube.
The O rings of the shut-off plunger are
worn-down or swollen.
The hose is clogged.
The pump tube is not tight enough.
EXTENSION LANCE:
Extentions for construction lines
E1000219511 brass with EPDM Seals for Acetone 1.0m
E1000219512 brass with FKM Seals for Solvent/Form Oils 1.0m
E1000219513 PVC with NBR Seals for Acid 1.0m .
FILTERS
E2888219011 Antidrip, 50 mesh, blue
E2002219026 Antidrip, 80 mesh, yellow
E2002219027 Antidrip, 100 mesh, green
E2888219012 No antidrip, 50 mesh, blue
E2002219078 No antidrip, 80 mesh, yellow
E2888219013 No antidrip, 73 mm, 50 mesh
CARRYING STRAPS
E1000501230
Janisset strap
E1000501268
Janisset economic
strap
5
SOLUTION
Check the piston sleeve. If it is worn-down
replace it and grease it, if not just grease
the edges.
Check the antenna and if necessary replace
the seal. Lubricate before reassembling.
Replace and grease the new O rings and
plunger
Loosen the hose clamp and check if the hose
or the tank outlet are clogged and if so,
proceed to unclog them with pressurized air
or water
Tighten the tube and grease the O ring.
E1000501336
Janisset strap with
hook ring style

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

320310

Tabla de contenido