Mx Onda MX-PI2633FLEX Manual De Usuario E Instalacion página 123

A(mm)
Before installing the induction hob, make sure that
The countertop surface is smooth and level, and no structural elements
interfere with space requirements
The hob is made of a heat-resistant material.
If the induction hob is installed above an oven, that the oven has a built-in
cooling fan.
The facility will comply with all authorization requirements and applicable
standards and regulations.
The electrical installation complies with local safety rules and regulations
and incorporates a suitable isolation switch or circuit breaker that provides
a total disconnection from the electrical network.
The isolating switch or circuit breaker must be adequate and provide a
3mm air gap contact separation on all poles (or on all active [phase]
conductors if local wiring rules allow for this variation of requirements )
The isolating switch or circuit breaker is easily accessible to the user.
Consult with a licensed electrician or local authorities regarding installation
and statutes, if in doubt about installation.
se easy-to-clean, heat-resistant finishes (such as ceramic tile) for the wall
surfaces surrounding the countertop.
At the end of the installation of the induction hob, make sure that ...
The power cord is not accessible through drawer or drawer doors.
There is adequate flow of fresh air from the outside of the cabinet to the
base of the counter.
If the induction hob is installed over a drawer or closet space, a thermal
protection barrier is installed under the base of the hob.
The isolating switch or circuit breaker is easily accessible by the user.
Before attaching the fixing brackets.
The unit must be placed on a stable and smooth surface (use the packaging).
Do not apply force to controls that protrude from the plate.
Attaching the fixing brackets
To fix the induction hob on the hob, you must first place the fixing brackets, use
the supplied screws (do not use other screws as they could damage the inside
of the induction hob).
B(mm)
760 50 mm
C(mm) D
20 mm Air inlet
20
E
Air outlet
10 mm