Mx Onda MX-PI2633FLEX Manual De Usuario E Instalacion página 125

3. The section of the power cables must withstand the current specified on
the nameplate.
To connect the induction hob to the mains socket, you must not use adapters,
reducers or branches, as these devices can become hot and cause a fire.
The power cable of the induction hob must not touch any part or area where it
acquires high temperatures and must be positioned so that the temperature will
not exceed 75˚C at any point.
Check with a licensed and qualified electrician for proper electrical installation.
Any modification to the electrical installation must only be carried out by a
licensed electrician.
The electrical connection of the induction hob must be carried out in
accordance with current regulations and protected by a single-pole
magnetothermic or automatic switch. The connection is shown below:
If the cable is damaged, to be substituted or replaced, the operation must
be carried out by an Official Mx Onda Technical Service.
If the induction hob is connected directly to the mains, a single-pole switch
must be installed with a minimum opening of 3 mm between the contacts.
The authorized installer must ensure that the correct electrical connection
has been made and that it complies with safety regulations.
The cable must not be bent or compressed.
The cable should be checked regularly and replaced only by authorized
technicians.
The yellow / green wire of the power cord must be connected to the earth
of the mains socket.
The manufacturer is not responsible for any accident resulting from the use
of an appliance that is not grounded or from faulty grounding continuity.
If the device has an electrical outlet, it must be installed so that the
electrical outlet is accessible.
22