Setup Of The Pyranometer; Checking The Com Port - Kipp & Zonen SMP12 Instrucciones De Servicio

4 | Installation and commissioning

4.5 Setup of the pyranometer

The pyranometer is delivered with the following factory settings:
– Modbus baud rate: 19200
– Parity: even
– Data bits: 8
– Stop bits: 1
– Address: 1
The pyranometer's settings can be adjusted using the Smart Explorer Software.
4 You can download the Smart Explorer Software and the manual at the following address:
http://www.kippzonen.com

4.5.1 Checking the COM port

After starting the Smart Explorer Software, you must select the COM port at which the operating system has
installed the converter.
4 Open the Windows Device Manager:
18 SMP12 Smart Pyranometer | EN