Kipp & Zonen SMP12 Instrucciones De Servicio página 24

4 | Installation and commissioning
4 Activate the Change Modbus address checkbox and set the new address.
4 Activate the Change Communication Parameters checkbox and select the baud rate and parity.
4 Click on the Next button.
ð The Update tab appears:
4 Click on the Update button to save the settings.
ð Following the update, the pyranometer is reset and is ready for operation again after approximately
1 minute.
ð The communication parameters are changed and the Connections tab appears.
24 SMP12 Smart Pyranometer | EN