Service Parts - Rational UltraVent Plus Manual De Instalación Original

en
5. Replace the particle filter on the front
side.
6. Mount the particle filter on the front
side.
Replacing the HEPA filter
It is recommended that the HEPA filter on
the condensation hood UltraVent be re-
placed annually.
a
The unit on which the condensation
hood is to be installed is disconnected
from the mains.
a
The condensation hood is disconnec-
ted from the mains.
1. Unlock the particle filter and remove
the particle filter on the left and right
[ Photo 38].
2. On the front left, remove the cover of
the electrical compartment
[ Photo 39].
3. Loosen the 2 screws on the left and
right of the front side, which attach the
front hood [
front section upwards.
4. Remove the 4 screws holding the filter
holder [ Photo
5. Pull the filter holder out of the con-
densation hood [
the filter holder over and place it on
top of the condensation hood.
6. Remove the 3 screws holding the
HEPA filter [
7. Replace the 2 HEPA filters
[ Photo 44].
8. Mount the HEPA filter, the filter cas-
sette, the electrical compartment cover
and the particle filter in reverse order.
26 / 160
Photo 40]. Remove the
41].
Photo 42], turn
Photo 43].
80.51.570_iCombi Pro-iCombi Classic_UV P_IM_V01_EU-west
7

Service parts

NOTICE
Availability of service parts
The service parts are available from the
catalogue of service parts.
7 | Service parts