Electrical Connection; Regulations For Electrical Connection; Connecting The Bus Cable - Rational UltraVent Plus Manual De Instalación Original

en
16. Only necessary with Combi-Duo: Re-
move the sealing plug from the back of
the condensation hood [
and grease the black seal in the open-
ing.
17. Secure the heat shield on the rear side
of the condensation hood with the 4
screws [ Photo
cables down the gap between the back
of the condensation hood and the heat
shield.
18. Only necessary with Combi-Duo:
Mount the pipe bracket on the rear
side of the condensation hood
[ Photo 20] and secure the exhaust
duct of the Combi-Duo superstructure
to the pipe bracket with hose clamps
and the connecting hose.

5.2 Electrical connection

DANGER
High voltages when connecting to the
mains power
Danger to life due to high voltage.
Disconnect from the power supply.
n
Make sure the unit is disconnected
n
from the power.
DANGER
Electric shock from incorrect
connection
There is a danger to life if the wires are
incorrectly connected.
Connect the wires correctly according
to their colour coding.
22 / 160
Photo 18]
19]. Guide the
80.51.570_iCombi Pro-iCombi Classic_UV P_IM_V01_EU-west
5.2.1 Regulations for electrical
connection
General information
The UltraVent condensation hood
n
must be connected to an electrical
supply in line with standards in your
country.
Before you disconnect the unit from
n
the mains or reconnect it to the mains,
make sure that the unit is switched off
to prevent the UltraVent condensation
hood from running.
The condensation hood must be fused
n
with a maximum of 16 A by the cus-
tomer.
Notes on the connection cable
The condensation hood must be
n
equipped with a power cable approx-
imately 2 metres long.
A separate power plug must be in-
n
stalled.
If the connection cable needs to be re-
n
placed, use a H05 RN-F 3 x 1.5 mm
quality cable.
The mains power cable may only be
n
replaced by qualified personnel au-
thorised by the manufacturer.

5.2.2 Connecting the bus cable

Combi-Duo: With a Combi-Duo super-
structure, the bus cable is first connected
in the upper unit as described below.
a
The condensation hood is installed on
the unit.
1. Remove the left side panel of the unit
(Combi-Duo: upper unit).
2. Break out one of the holes above the
media outlets on the rear side of the
unit [ Photo
5 | Installation
21].
2