Engine Maintenance; Service And Maintenance; Maintenance Schedule - Craftsman CX Serie Manual Del Operador

Before performing any type of maintenance/service, disengage all controls and stop
the engine. Wait until all moving parts have come to a complete stop. Remove the key
to prevent unintended starting. Always wear safety glasses during operation or while
performing any adjustments or repairs.
Interval
Each Use 1.
2.
3.
1st 5 - 8 hours 1.
25 hours 1.
2.
50 hours 1.
Annually or 100 hours 1.
Before Storage 1.
† Under heavy load or in high temperatures

ENGINE MAINTENANCE

Checking Engine Oil
Before lubricating, repairing, or inspecting, disengage all controls and stop
engine. Wait until all moving parts have come to a complete stop. Remove the
key to prevent unintended firing of the engine.
NOTE: Check the oil level before each use to be sure correct oil level
is maintained.
When adding oil to the engine, refer to viscosity chart below. Engine oil capacity
is approximately 37 ounces. Do not over-fill. Use a 4-stroke, or an equivalent high
detergent, premium quality motor oil certified to meet or exceed U.S. automobile
manufacturer's requirements for service classification SG, SF. Motor oils classified
SG, SF will show this designation on the container.
1. Remove the oil filler cap/dipstick and wipe the dipstick clean.
2. Insert the cap/dipstick into the oil filler neck, but do
NOTE: On some engines, a threaded screw cap will be present instead of
the quarter turn locking cap. In the instance of a threaded oil cap/dipstick,
DO NOT screw the cap/dipstick in to check. Check the oil by resting the cap/
dipstick on the threads, but not screwing it in.
3. Remove the oil filler cap/dipstick. If level is low, slowly add oil until oil level
registers between high (H) and low (L). See Figure 18.
4. Replace and tighten cap/dipstick firmly before starting engine.

SERVICE AND MAINTENANCE

MAINTENANCE SCHEDULE

WARNING
Item
Engine oil level
Loose or missing hardware
Unit and engine.
Engine oil
Engine oil†
Control linkages and pivots
Engine oil
Spark plug
Fuel system
WARNING
screw it in.
not
Follow the maintenance schedule given below. This chart describes service
guidelines only. Use the Service Log column to keep track of completed
maintenance tasks. To locate the nearest Sears Service Center or to schedule
service, simply contact Sears at 1-800-4-MY-HOME®.
Service
1. Check
2. Tighten or replace
3. Clean
1. Change
1. Change
2. Lube with light oil
1. Change
1. Clean and re-gap, or else replace with
new plug.
1. Run engine until it stops from lack of fuel
or add a gasoline additive to the gas in
the tank.
Fill
between
high
and low
marks
Changing Engine Oil
NOTE: Change the engine oil after the first 5 hours of operation and once a
season or every 50 hours thereafter.
1. Drain fuel from tank by running engine until the fuel tank is empty. Be sure
fuel fill cap is secure.
2. Place suitable oil collection container under oil drain plug.
3. Remove oil drain plug. See Figure 19.
18
Service Log
Figure 18