Publicidad
Step 2
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten a EXTENSION RAIL (40MA) to the RIGHT END (A). Use two SILVER 1/2" FLAT HEAD SCREWS (128S)
through holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the RIGHT END. Turn a SCREW
into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
40MC
Push the black lever in and pull the SLIDE from the RAIL.
4
www.sauder.com/service
3
2
1
A
Open end
SILVER 1/2" FLAT HEAD SCREW
426510
40MA
128S
(2 used for the RAILS)
7
Page 7
Publicidad
