Technical Data; Noise/Vibration Information; Declaration Of Conformity; Assembly And Transport - Bosch GTM 12 Professional Manual Original

OBJ_BUCH-302-005.book Page 56 Tuesday, June 9, 2009 2:19 PM
56 | English

Technical Data

Combination Saw
Article number
3 601 M15 ...
Rated power W
input
Rated voltage V
Frequency Hz
-1
No-load speed min
Laser type
Laser class
Weight according kg
to
EPTA-Procedure
01/2003
Protection class
Permissible workpiece dimensions (maximal/minimal):
Chop/mitre saw, see page 62
Table saw, see page 67
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dimension of suitable saw blades
Saw blade diameter
Blade thickness
Mounting hole diameter

Noise/Vibration Information

Measured values determined according to
EN 61029.
Typically the A-weighted noise levels of the
product are: Sound pressure level 98.5 dB(A);
Sound power level 111.5 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
1 609 929 U05 | (9.6.09)

Declaration of Conformity

We declare under our sole responsibility that
GTM 12
the product described under "Technical Data" is
Professional
in conformity with the following standards or
standardization documents: EN 61029,
... 0.. ... 060
EN 60825-1 according to the provisions of the
directives 2004/108/EC, 98/37/EC (until
1800 1650
28 Dec 2009), 2006/42/EC (from 29 Dec 2009).
Technical file at:
230 110
Robert Bosch GmbH, Dept. PT/ESC,
50/60 50/60
D-70745 Leinfelden-Echterdingen
4300 4300
Dr. Egbert Schneider
650 nm, 650 nm,
Senior Vice President
< 1mW < 1mW
Engineering
2 2
22.5 22.5
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 01.06.2007
/II /II

Assembly and Transport

Delivery Scope

Carefully remove all parts provided from their
packaging.
mm 300–305
Remove all packing material from the power tool
mm 1.5–2.5
and the accessories provided.
mm 30
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Combination saw with pre-mounted saw
– Allen key/slotted screwdriver 5
– Dust bag 8
Additionally for table saw:
– Parallel guide 63
– Hold-down stick 64
– Lower saw blade cover 68
Dr. Eckerhard Strötgen
Head of Product
Certification
Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.
blade
Bosch Power Tools