Assembly And Operation; Removal And Installation Method Of Battery; Charging Method - Metabo HPT G 1812DF Instrucciones De Seguridad Y Manual De Instrucciones

APPLICATIONS
○ Removal of casting fi n and fi nishing of various type of
steel, bronze and aluminum materials and castings.
○ Grinding of welded sections or sections cut by means
of an acetylene torch.
○ Grinding of synthetic resins, slate, brick, marble.
WARNING
To avoid the risk of serious injury, NEVER use
this grinder with cup wheels and/or saw blades.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Fig. 5).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities
(see Fig. 5).
Latch

ASSEMBLY AND OPERATION

Pull out
Insert
Push
Battery
Fig. 5

CHARGING METHOD

NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn up.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Firmly Insert the battery into the battery charger as
shown in Fig. 6.
Charge
indicator lamp
English
Battery
Guide rail
Fig. 6
13