Prior To Operation - Metabo HPT G 1812DF Instrucciones De Seguridad Y Manual De Instrucciones

English
○ When charging of the battery is complete, USB
charging is paused for about 5 seconds while it
performs a check.
○ When the remaining battery capacity is extremely
low, the charger will prioritize the charging of the
battery and temporarily stop USB charging, but the
USB charging will automatically resume when the
remaining battery capacity reaches a certain level.

PRIOR TO OPERATION

1. Power switch
Ensure that the switch is in the OFF position.
2. Check your work environment
Ensure the following before operation:
○ No fl ammable gas, liquid, or object at worksite.
○ When grinding thin steel sheet it may cause a high
booming noise.
To avoid such noise, place a rubber mat under the
workpiece.
○ Clear the area of children or unauthorized
personnel.
3. Mounting the wheel guard
Be sure to mount the wheel guard at an angle that will
protect the operator's body from injury by a broken
wheel piece.
[Installing Wheel Guard] (Fig. 9)
○ Open and hold the lever, then install the wheel guard
so that the projection on the wheel guard aligns with
the recess in the packing gland.
○ Rotate the wheel guard to an angle suitable for use,
then release your fi nger from the lever.
○ Rotate the wheel guard left or right until it locks into
place.
Packing gland
Lever
16
Wheel guard
Fig. 9
WARNING
If the wheel guard is not attached properly, a
broken wheel may result in and cause death or
serious injury.
4. Thoroughly check that the depressed center wheel
is free of cracks, splits and other abnomalities before
mounting. Make sure it is fi rmly clamped and has
been properly mounted. Refer to "Depressed Center
Wheel Assembly and Disassembly" (Fig. 17)
5. Test the grinder before using.
Before actually beginning the grinding work, test the
grinder by fi rst clearing the area of all other personnel.
Make sure the wheel guard is in place and that you
are wearing eye protection. Turn the grinder "on", and
make sure the grinder runs smoothly and shows no
abnormalities.
Duration of the trial run is as follows:
When depressed center wheel is replaced ...........
..................................................3 minutes or more
When starting daily work .........1 minute or more
6. Use only properly rated depressed center wheels.
Use only depressed center wheels rated at
13,300 /min or more.
Using a depressed center wheel rated less can lead
to wheel disintegration during operation and cause
serious bodily injury.
7. Check the push button.
Make sure that the push button is disengaged by
pushing push button two or three times before turning
on the grinder. (Fig. 10)
Push button
8. Fixing the side handle
Screw the side handle into the gear cover (Fig. 11).
Fig. 10
Side handle
Fig. 11