IRUDEK PRO11 Manual De Instrucciones página 9

REPAIR INSTRUCTIONS
If the equipment is damaged, it will not provide the optimum level of protection and must be replaced or repaired
immediately. If in doubt, consult the manufacturer before carrying out any repairs.
The equipment should be repaired only by the manufacturer or a person authorised for this purpose, following the
procedures established by the manufacturer.
MARKING: The equipment is marked with the next information:
i) CE marking, Conformity to European Legislation
ii) Identification of the manufacturer
iii) Reference of the equipment
iv) Lot number or serial number
v) Year of manufacture
vi) European Norm
vii) Notified body number
INSTRUCTIONS FOR PERIODIC EXAMINATIONS
It is necessary to carry out regular periodic examinations. The safety of the users depend upon the continued efficiency
and durability of the equipment.
The personal protective equipment shall be examined at least every 12 months. The periodic examination can only be
carried out by the manufacturer or his authorized representative.
The comments should be included in the check card of the equipment. After the periodic examination, the next due date
for periodic examination will be determined.
During periodic inspection it is necessary to check the legibility of the equipment marking
CHECK CARD
The check card should be filled in before the first use.
All information about the personal protective equipment ( name, serial number, date of purchase and date of putting into
operation, user name, periodic examination and repair history, and next periodic examination date ) shall be noted into
de check card.
All records in the check card can only be filled in by a competent person.
Do not use the personal protective equipment without a duly filled check card.
EQUIPMENT RECORD
REFERENCE
SERIAL NUMBER
YEAR OF MANUFACTURE
IT CAN BE USED WITH
DATE OF PURCHASE
DATE OF FIRST PUT INTO USE
USER NAME
COMMENTS