Klarstein LIMELIGHT 120 Manual De Instrucciones página 53

To clean the grease filters:
• Remove the grease filter.
• Perform one of the following steps to clean the filter:
• Manual cleaning (max. 30 °C): Soak the filter in water with a mild, non-
caustic grease-dissolving detergent for about 3 minutes
• Cleaning in the dishwasher (max. 30 °C):
Place the filter in the dishwasher and run a programme with a mild, non-
caustic, grease-dissolving detergent.
Note: It is advisable not to use rinse aid. The filter should be cleaned separately
from dishes and kitchen utensils. Carefully brush the filter with a soft brush. Do
not apply too much pressure to avoid damaging the filter. The filter may fade to
grey. This is normal and is not covered by the warranty.
Replace activated carbon filter
Replace the activated charcoal filter every 3 to 6 months (see section: "Installing
the activated charcoal filter (optional)").
Replacing the lamp
• The lamp may only be replaced by a qualified electrician.
• Disconnect all power connections before opening the appliance.
• There is a risk of burns! Always allow the lamp to cool down before replacing
it.
• Always use gloves or a cloth to avoid direct contact with your hands. Direct
contact can shorten the life of the lamp.
EN
53