Attaching Duct Collars - SantaFe ULTRA Serie Instrucciones De Instalación

ATTACHING DUCT COLLARS

5
1. Outdoor Air Ventilation Duct
Outdoor air ventilation is optional. If setting up the unit to provide outdoor air ventilation, see page 18.
2. Return Air Inlet
A 10" diameter duct collar is attached to the unit.
3. Supply Air Outlet
The back panel of the dehumidifier can be rotated to allow for horizontal flow through or vertical flow through of
the supply air.
a. Horizontal Flow Through
The unit ships configured for a horizontal flow through. A 10" diameter duct collar is attached to the unit.
b. Vertical Flow Through
Remove the exhaust panel using a T25 torx bit. Rotate the panel so the exhaust collar is located on the top
of the unit. Align screw holes and snap the panel onto the base. Secure the exhaust panel to the base by
replacing the six screws.
Horizontal Flow Through Horizontal Flow Through
(End Discharge) (End Discharge)
A A
Air Air
Flow Flow
B B
6" Optional Outdoor Air Intake 6" Optional Outdoor Air Intake
A A
10" Return Air Inlet 10" Return Air Inlet
B B
10" Supply Air Outlet 10" Supply Air Outlet
C C
Front View Front View
A A
B B
800.533.7533 | Santa-Fe-Products.com
C C
Rear View Rear View
C C
Vertical Flow Through Vertical Flow Through
(Top Discharge) (Top Discharge)
A A
Air Air
Flow Flow
B B
6" Optional Outdoor Air Intake 6" Optional Outdoor Air Intake
A A
10" Return Air Inlet 10" Return Air Inlet
B B
10" Supply Air Outlet 10" Supply Air Outlet
C C
Front View Front View
Top View
A A
B B
Santa Fe ULTRA98/120 Installation & Operation Instructions
C C
Rear View Rear View
Top View
C C
7