Humanscale Float Instrucciones De Montaje página 5

Attach Worksurface
1
Place your worksurface upside down on a
protective surface. Flip your table base upside
down and align the base to the worksurface per
the following sections:
A - Humanscale Worksurface
Align the table base to the following pilot holes
highlighted below.
Note: For product purchased with a worksurface in
North America, only the four (4) outer corner pilot
holes are included for alignment depending on the
size of your worksurface. For Product purchased
outside of North America, all pilot holes are
included.
Legend
Float Base
Float Hand Switch
48" Wide Worksurfaces
Float Crank
NeatTech Small for a 48"-54" wide worksurface
NeatTech Large for a 60"-72" wide worksurface
(30" Deep Worksurfaces only)
Keyboard Tray
Not applicable with this table
5