Preliminary Checks - Beninca SAM Serie Manual Del Usuario

Automation for the motorisation of gates where physical size, pillars or columns with large dimensions prejudice use of traditional actuators.
SAM is equipped with an articulated arm that allows regular and silent movements. It is easily applied and, with its pleasant design, can
meet the most demanding expectations.
- The reaction to impact is carried out thanks to amperometric detection integrated in the control panel.
- Stoppage in opening is adjustable using the mechanical lock integrated in the actuator.
- Stoppage in closure is standard thanks to the particular shape of the articulated arm, an optional mechanical stop is however available
to apply to the actuator.
- The emergency release is a lever with customised key and allows manual movement of the gate in the event of a power cut.
For proper operation of the automation, the door to automate must have the following features:
• Good strength and rigidity of the gate.
• Efficient hinges.
• The gates move manually and without force for the entire stroke.
On the contrary, replace the faulty parts.
The reliability and safety of the automation depends on the gate structure status.
TECHNICAL DATA
Mains power supply
Motor power supply
Absorbed power
Absorption
Torque
Output shaft speed
Max. no. of continuous ma-
noeuvres
No. manoeuvres in 24h
Degree of protection
Working temperature
Opening time (90°)
Noise
Lubrication
Incorporated control panel
Dimensions
Weight
Dimensions expressed in millimetres.
SAM.E24 Irreversible gearmotor 24Vdc with incorporated control panel CP.SAM.
SAM.24
Irreversible gearmotor 24Vdc
SAM.BA: Articulated arm for SAM
Optional accessories
SAM.CB: Brackets kit for installable batteries on board (pack 5 pcs)
SAM.STOP: Additional mechanical stop (pack 2 pcs)
SAM.LOCK: Lock with customised key
SAM.SE :
Wire release for emergency opening from outside
SAM.BS Sliding arm
SAM.SN Articulated arm for sloped gates
GENERAL INFORMATIONS

PRELIMINARY CHECKS

TECHNICAL DATA AND USE LIMITATIONS
SAM.E24
SAM.24
115-230 V
--
(50-60 Hz)
24 V �� (switching power supply)
115 W 135 W
~
230V : 1,9 A
5 A
~
115V : 3,5 A
220 Nm
2 rotations/min
30 manoeuvres/h
60
IP44
-20°C / +50°C
14s (including slowdown)
Lpn < 70 dB (A)
Grease
NO YES
See Fig.1
6 kg 7,9 kg
DIMENSIONS - FIG.1
VERSIONS AND ACCESSORIES
~
GATE LENGTH (m)
1.0
1.5
2.0
2.3*
2.5*
*ATTENTION!: electric lock compulsory
USE LIMITATIONS
MAXIMUM GATE WEIGHT (kg)
300
285
250
200
150
EN
25