Nemaxx P6 Instrucciones De Uso Originales página 16

ATTENTION:
During the flame switching off phase and exchanger cooling, you should not switch
the stove on again until the cycle ends;
this state is signalized by the display 'SWITCHING OFF'
HOWEVER, it is possible to switch off the heater in every functioning phase.
Turning off the heater is done by pressing the button ON/OFF
make sure the stove is under your supervision, until "Stabilization".
After you push the button the word „Cooling" will show on the display.
After the stove's temperature sinks, the stove will start again, Cleaning-feeding-lighting-stabilization.
How to make the stove skip to the process Stabilization when you think the flame is ok and/or
the stove can work properly?
Push for 3 seconds, and then it will turn directly to Stabilization.
ATTENTION:
If the heater is switched off, the flame will continue burn until the fuel exhaustion
in the melting pot, this will happen in automatically, this can last up to 5-8 minutes.
The switching off phase is displayed by the message 'SWITCHING OFF".
This will show up to the end of the operation. Whether the heater is switched on or not.
The display will display the hour, the power, and the planned set temperature.
NOTE:
Before first usage it is necessary to put a hand of pellets to the fire pot.
NOTE:
if the ignition fails, the thermal control will shut off the stove automatically.
Meanwhile, E2 (Error for the ignition failure), will be shown on the display.
If you want to restart it, please check the stove as usually and clean the fire pot.
After that, push
Follow the above process to ignite and start again.
EN
to clear the word E2.
16
for two seconds;
Version: 11
08.11.2022