Nemaxx P6 Instrucciones De Uso Originales página 37

No feeding after 20 seconds of starting.
There are three stages for the feeding process.
Stage one is during the first several minutes, feeding is constant. „Feeding" is showing on the LCD
display
Stage two is the following couple minutes, the feeding light is off.: „Light" showing on the display
The last stage is that feeding will be done every several seconds all the time after previous stages.
For the first stage (during first
several minutes)
For the second stage
Regarding the last stage
Feeding not properly
too much wood pellet and cannot
burn in time
The fire is off, not enough wood
pellets can be burned
After ignition the power is off
15 min later.
E
Feed unit is blocked.
There is a problem with the
connection between motor
and auger
No fuel in the hopper
It is normal
Feed unit is blocked.
There is a problem with the
connection between motor
and auger
No fuel in the hopper
The level of feeding speed
is too high
The level of feeding speed
is too low
Pellet feeder unit is off or
pellet is too little.
30˚C temperature switch
breaks or the connection
wires of the switch are loose.
Pressure Switch is broken
in the stove
37
Check the auger is blocked
or not.
Check the screws between
auger and motor if they are
loose or not.
Or the auger might jump out
Fill the fuel into the hopper
Please be patient
Check the auger is blocked
or not.
Check the screw between
auger and motor if it is
loose or not or the auger
might jump out
Fill the fuel into the hopper.
Accelerate the combusti-
on fan's speed or Feeding
quantity
Lower the combustion fan's
speed or feeding quantity
Check the pellet feeder unit
and restart.
Check the connection wires
or change the 30˚C
temperature switch.
Replace or repair the device
Version: 11
08.11.2022