Installing Hoses - DeWalt DXCM603 Manual De Instrucciones

PUMP
The pump compresses air into the tank. Working air is not
available until the pump has raised the tank pressure above that
required at the air outlet.
MOTOR OVERLOAD PROTECTOR
The motor has a thermal overload protector. If the motor over-
heats for any reason, the overload protector will shut off the mo-
tor. The motor must be allowed to cool down before restarting.
To restart:
1. Set the Auto/Off switch to OFF (0) and unplug unit.
2. Allow the motor to cool.
3. Depress the red reset button (T) on the motor.
4. Plug power cord into the correct branch circuit receptacle.
5. Set the Auto/Off switch to AUTO (1).
Fig. 12 Fig. 13
Installation
Unpack the air compressor. Inspect the unit for damage. If the
unit has been damaged in transit, contact the carrier and com-
plete a damage claim. Do this immediately because there are
time limitations to damage claims.
Description
Air compressor
Instruction manual
Check the air compressor serial label to ensure that you have
received the model ordered, and that it has the required pressure
rating for its intended use.

INSTALLING HOSES

WARNING: Risk of unsafe operation. Firmly grasp hose in hand when
installing or disconnecting to prevent hose whip.
1.
Fig. 14
2.
3.
NOTICE: Assembling quick connect bodies to air outlet and
quick connect plugs to hose ends make connecting and
disconnecting hoses simple and easy. Quick connect bodies
and plugs are available for purchase from your local dealer or
authorized service center.
11
The Carton Should Contain
Ensure regulated pressure gauge reads 0 PSI (0 kPa).
Apply sealant tape to hose threads.
Assemble hose to air outlet (H). IMPORTANT: Do not assem-
ble splitters directly to the air outlet (H) (Fig 2).
Quantity
1
1