Installation - cecotec BOLERO AGUAZERO 1006 COMPACT Manual De Instrucciones

ENGLISH

3. INSTALLATION

Step 1: Selecting the dishwasher location
Connecting the electric supply, the water supply and the drain
- When placing the machine, do it in an area in which the tableware can be loaded and
unloaded easily. Do not place the dishwasher in an area in which room temperature is
below 0°C.
- If you want to install the dishwasher in an existing cabinet, you must make sure there is
enough space to do so and that the wiring and plumbing are appropriate.
- Place the dishwasher near a tap, a water drain and a grounded electrical outlet. Remember
you should not modify the connections once the dishwasher is installed.
- You must leave at least 5 mm space between the upper part of the dishwasher and the
cabinet, and the exterior door must be aligned with the piece of furniture.
- Follow the indications on image 2 on the dimensions the gap where you want to
install the dishwasher must have.
- WARNING: the worktop under which you want to install the dishwasher must be
stable in order to avoid imbalances.
- If you want to install the dishwasher in the corner of a cabinet, you must make sure there
is enough space to open the door completely. Fig. 3
1. Dishwasher
2. Dishwasher door
3. Minimum space of 5 mm
4. Cabinet
Note
- Leave an appropriate distance around the machine to make its disconnection from the
mains and movement easier when cleaning it.
- Do not hold the device by its door or panel.
Step 2: Water supply hose connection
Fig. 4
- Connect the water supply hose to a cold water tap, and make sure it is secured in place.
WARNING: use the water supply hose provided with your dishwasher, do not reuse the
water supply hose from your old dishwasher.
WARNING: open the tap and let water run through the water supply hose before
connecting it to the dishwasher.
WARNING: connect the water supply hose directly to the water inlet. The pressure
64