Thread the upper thread
1. Rotate hand wheel in counterclockwise
direction, so as to make take-up lever at the
top position;
2. Raise the lifting lever;
3. Put the reel into the reel base;
4. Pull thread pass the winder holder and pull
forward as arrow indicates in the figure;
5. Bypass threading plate;
6. Slide into hole of take-up lever and then pull
downward;
7. Put threading hook of needle clamp on it,
cross needle through hole from the operator
side to another side;
8. Pull out thread about 15-20 cm and cut it at
the tread cutter on the face plate
Note: thread the upper thread under power
off.
Guide the lower Thread (Bobbin Thread)
Lightly pull the upper thread end through needle eye by left
hand and rotate hand wheel by right hand as arrow indicates
in the figure, so that sewing needle can be inserted into
needle plate.
1. Continuously rotate hand wheel, pull thread end until
needle returns to the
top
position; the lower thread (bobbin
thread) is pulled out as shown in the figure.
2. Pull out both the lower and upper threads about 15cm,
pass through presser
foot
and arrange them forward.
P-10