Zipper Sewing; Replace Bulb; Clean Feed Dog And Shuttle Race - Premier MCO-5199 Manual De Instrucciones

Zipper Sewing

1. Replace presser foot of zipper;
2. Select pattern of straight sewing;
3. When the right side of zipper is sewed, mount the presser
foot at the left groove, put zipper teeth along the cloth edge
and fix it by brooches, and then let right side of zipper teeth
close to the presser foot and sew it;
4. Stop sewing before the presser foot contacts zipper end,
and leave needle in cloth and fix the cloth, raise the presser
foot and pull the zipper end toward the sewed place, and then
sew it continuously.
5. When the left side of zipper is sewed, mount the presser
foot at the right groove, let left side of zipper teeth close to the
presser foot and sew it.
Replace Bulb
- Shut off power before bulb is replaced.
- Replace bulb with the same specification (220-240v
15W)
Procedures:
1. Loosen screw "A" by screwdriver;
2. Remove face plate "B"
3. Rotate bulb in "-" direction and remove it; and
replace a new one, rotate it in "+" direction and tighten
it.
Note: Be careful against scald during bulb
replacement; it is preferential to replace bulb when
it is cool down.
Clean Feed Dog and Shuttle Race
P-15