Steelcase 1 Serie Manual De Instrucciones página 2

®
Remove 3D Microknit /
Flexor Back Assembly
NOTE: Extend chair to maximum height
with height adjustment lever and slide
seat to most forward position.
1.
Remove Flexor screws (4x).
2.
Pull out the bottom Flexor assembly.
3.
Push the side of the plastic
flexor toward the frame with flathead screw driver,
then pull out to disengage the Flexor
assembly from the frame. Repeat for other side.
4.
Unhook the black strip attached to the
upholstery from the Flexor assembly flanges.
NOTE: Use flathead
screw driver
4
View from Underneath
Backside
1
T-20
T-15
3
2
Page 2 of 20
P/n 1504551001
Doc # 162337 Rev A