Toyotomi KS-R26 Instrucciones De Uso página 13

D
A D J U S T I N G T H E F L A M E
After you have ignited the heater, it will take 30 minutes for the flame to become
visible in the combustion chamber. Only then can you check whether the flame
is correct. Too high a flame may cause smoke and soot, whereas too low a flame
causes smells. The page opposite the folding page shows the minimum and
maximum permissible burning heights of the flame (Fig. K). The flame can be
adjusted with the wick adjuster knob · (Fig. I).
Burning that is too low may be caused by:
¼ insufficient fuel
¼ poor fuel quality
¼ insufficient ventilation
¼ wastage of the wick
✗
E
SWITCHING OFF THE HEATER
Then slowly turn the wick adjuster knob · counter-clockwise to its stop. The
flame will extinguish after a little while.
For routine turn-off, DO NOT use the "Safety button" or activate the
!
"Automatic Extinguisher" by jarring the heater. These methods may cause
unwanted odour, soot and smoke. Only the wick adjuster knob should be used
for normal shutoff.
!
In case of an emergency, switch off the heater by pushing down the safety button
(Fig. L).
F
MALFUNCTION, CAUSES AND SOLUTIONS
If any malfunctioning cannot be solved from the directions below, please contact
your dealer.
THE HEATER DOES NOT IGNITE
¼ The batteries are not positioned correctly in the holder.
Check (Fig. D).
¼ There is not enough power left in the batteries for the ignition.
Replace (Fig. D).
¼ You have run out of fuel from the tank or the wick has been replaced.
After having refilled , wait for 30 minutes before igniting the heater.
(fill the tank)
(contact your dealer)
(leave window or door ajar)
(contact your dealer or replace the wick,
refer to Section L)
✓ ✗
K
I
I
L
D
-
+
4
7