Applying The Cuff - Topcom BD-4620 Manual De Usuario

10 Settings
10.1 Time, date and measuring unit adjustment
• When the batteries are installed for the first time, the year will flashes on the
display automatically. When you already used the monitor before you have to press
for 3-4 seconds the "SET" button in the off position, the year will flashes on the
display.
• Press the "MEM" button for increasing the year, use the "SET" button to confirm the
desired year.
• Change the months, days, hours and minutes as described above, using the
"MEM" button to increase and use the "SET" button to confirm every setting.
• After setting the minutes press "SET" and the current unit will appear. Use the Set
button to choose between kPa or mmHg.
• Press the "start/stop" button to save the current settings and turn off.
10.2

Applying the cuff

1. Remove all watches, jewelry, etc. prior to attaching the wrist
monitor. Clothing sleeves should be rolled up and the cuff
should be wrapped on bare skin for correct measurements.
Apply cuff to left wrist with palm facing up.
2. Make sure the edge of the cuff is about 1 cm from the palm. In
order to insure accurate-measurements.
3. Fasten the velcro strap securely around your wrist so there is
no extra space between the cuff and the wrist. If the cuff is not
wrapped tight enough ,the measurement values will be false.
4. If your physician has diagnosed you with poor circulation on
your left arm, place the cuff around your right wrist.
TOPCOM BD-4620
11