Duronic HV180 Instrucciones De Uso página 11

Operating Instructions
Please read these instructions in full before using this heater and retain for future
reference.
When not in use:
Check that the power switch dial is turned OFF [0]
(Fig 1) and the temperature control dial is turned
OFF (Fig 2).
Fig 1 Fig 2
Connecting the Power:
Plug the power cable into a suitable mains socket (rated not less than 10 AMP).
Once plugged in and the socket is switched on, the light indicator will turn on.
Setting the Temperature:
Select the temperature you prefer and the heater will
heat the room to the chosen temperature and then turn
off automatically.
When the indoor temperature drops below the set
temperature, the heater will start to work again
emitting heat until the indoor temperature reaches the
desired temperature once again. This cycle will repeat to maintain your chosen
temperature. The temperature can be adjusted by simply turning the temperature
control dial to the temperature you want.
Switching on the Heater:
To turn the heater on, rotate the power dial to your
preferred power level:
[ I ] Setting 1: 900W
Low Power High Power
[ II ] Setting 2: 1800W
Setting Setting
11