Mounting Installation - Furrion DV3100 Manual De Instrucciones

Before Operation

Mounting Installation

Location
1. Choose a mounting location away from humid areas, water sources, appliances or any
equipment that can radiate heat.
2. Select an area on a wall or cabinet which is free from cable, fuel or brake lines and ensure
the area behind the wall mount stereo has a vent hole or if it is an enclosed box and has
adequate room around the rear of the unit for cooling.
3. Ensure when the stereo is mounted in the cut out that the wires at the rear of the unit are
not pressed against the heat sink.
Installing the unit
1. Before finally installing the unit, connect the wiring temporarily and make sure the unit and
the system work properly.
2. Fix the unit with screws according to following diagram.
● Remove plastic shell of the front panels from the unit.
● Fix the unit with 4 pieces #8 pan head self tapping screws.
● Put back plastic shell of the front panel to the unit.
SCREW
15
CCD-0005528 | REV DATE: 11.29.22
SCREW
PLASTIC SHELL OF
THE FRONT PANEL