Radio Operation; Stereo/Mono Button - Furrion DV3100 Manual De Instrucciones

Radio Operation

Frequency Select
In RADIO mode, press and hold PLAY/PAUSE
button for about 5 seconds to select your
desired frequency EUROPE, USA1, USA2 or
AUSTRALIA.
AM/FM BUTTON
In RADIO mode, press and hold INPUT MODE
button on the front panel or briefly press AM/
FM button on the remote control to select
your desired radio band of FM1, FM2, FM3,
AM1, AM2, and the selected band will be
displayed on the LCD of the front panel.
TUNE/SEEK UP/DOWN
In RADIO mode:
1. Press and hold
the front panel or press and hold
/ button on the remote control
to automatically search down/up for
a available station from the current
frequency.
2. Press or
panel or press
remote control to manually search up or
down with step by step for your desired
station from the current frequency.
APS BUTTON
In RADIO mode:
1. When pressing and holding APS button
on the remote control or press and hold
button on the front panel, the radio
searches from the lowest frequency and
checks the signal strength level until 1
cycle search is finished. And then the
6 strongest stations are preset to the
corresponding preset number memory
bank. The AS operation is implemented in
each bank of the selected band. When the
AS operation is finished, it will resume
broadcasting on the M1. (It can store 3x6
stations for FM and 2x6 stations for AM
in all)
17
or button on
button on the front
/ button on the
CCD-0005528 | REV DATE: 11.29.22
2. When briefly pressing APS button on the
remote control or press
front panel, the radio searches for each
preset station from the M1. When the field
strength level is more than the threshold
level of the stop level, the radio holds at
that preset number for a few seconds
with releasing mute, and then searches
again. After finishing a circle of searching,
it will stop searching on the M1.
NOTE:
In FM band, FM1, FM2,FM3 is checked
once at a time.
In AM band, AM1, AM2 is checked once at
a time.
PRESET STATION (1-6) BUTTONS
In RADIO mode:
1. To memorize the current frequency on the
current band, press and hold any one of
the six preset buttons (1-6).
2. To recall the preset memory on the
current band, press one of the preset
buttons (1-6).

STEREO/MONO BUTTON

Press ST button on the remote control to
select the STEREO or MONO sound mode for
FM band.
LOC BUTTON
1. In RADIO mode, when the signals of the
distance radio stations are very weak and
the receiving effect is bad during tuning,
press LOC button on the remote control to
turn off the LOC function, then tune again
for the distance radio station.
2. In RADIO mode, when the signals from
the local radio stations are too strong,
this could lead to interference. Press LOC
button on the remote control to turn on
the LOC function, re-tune for the local
station required.
button on the