Connecting To External Speakers Or Headphones - Philips NeoPix Ultra 2 Manual De Usuario

VGA
2 On your computer, adjust the screen
resolution of the computer to the correct
setting and switch the VGA signal to an
external monitor. The following resolutions
are supported:
Resolution
VGA 640 x 480
SVGA 800 x 600
XGA 1024 x 768
WXGA 1280 x 768
HD 1280 x 720
FULL HD 1920 x 1080
3 Press to display the input source list,
and then select VGA.
Connecting to external
speakers or headphones
Connect external speakers or headphones to
the projector. With this connection, audio from
the projector is played through the external
speakers or headphones.
DANGER!
Danger of hearing damage!
Before connecting the headphones,
turn down the volume on the projector.
Do not use the projector over a longer
time at high volume – especially when
using headphones. This could lead to
hearing damage.
1 Using a 3.5 mm audio cable, connect the
connector on the projector to the analogue
audio input (3.5 mm jack, or red and white
jacks) on the external speakers. Or connect the
connector on the projector to headphones.
Connect to playback devices
Image refresh rate
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
• The speakers of the projector are
deactivated automatically when the
external speakers or headphones are
connected to the projector.
AV MICRO SD
2 When connecting to the headphones, use
the volume control on the remote control to
adjust the volume to a comfortable level.
HDMI 1 HDMI 2 USB DC
15