Teac T-R460 Manual Del Usuario página 15

TROUBLESHOOTING
Before calling for service, check through the chart below for probable causes of the problems you experience while
using this unit.
Problem
No sound.
Only noise is heard.
Broadcasting is received but with noise.
The PRESET CALL buttons on the remote
control do not work.
SPECIFICAT I O N S
FM Section
Tuning Range :
87.5 MHz - 108.0 MHz (100 kHz steps)
(General Export)
87.5 MHz - 108.0 MHz (50 kHz steps) (Europe)
Usable Sensitivity (IHF) : Mono : 10 dBf
50 dB Quieting Sensitivity :
Mono : 17 dBf
Stereo : 33 dBf
Alternate Channel Selectivity (98 MHz ±400 kHz) :
65 dB
Image Response Ratio : 70 dB
Frequency Response : 20 Hz - 15 kHz, +0.5 dB/ –3 dB
Capture Ratio : 2 dB (at 98 MHz)
Distortion (at 65 dBf, 98 MHz) :
Mono : 0.1%
Stereo : 0.3%
Signal-to-Noise Ratio (at 65 dBf, 1 kHz) :
Mono : 70 dB
Stereo : 65 dB
AM Suppression Ratio : 55 dB
Stereo Separation (1 kHz) : 40 dB
Output (Level/Impedance) : 800 mV/ 2.2 kohm
Probable cause(s)
INPUT SELECTOR of amplifier is not set to
"TUNER".
VOLUME of amplifier is set to the ∞ position.
The terminal for system connection is
pulled out.
The antenna is pulled out.
The frequency is not detected exactly.
The position of antenna is not suitable.
The power of CD is turned on.
The remote control is set to a mode other
than TUNER.
AM Section
Tuning Range :
530 kHz - 1,720 kHz (10 kHz steps) (General Export)
522 kHz - 1,620 kHz (9 kHz steps) (Europe)
Usable Sensitivity : 55 dB/m (562 µV/m, Loop Antenna)
Selectivity : 55 dB (at ±9 kHz)
Image Response Ratio : 35 dB
IF Response Ratio : 60 dB
Distortion : 1% (at 85 dB/m)
Signal-to-Noise Ratio : 40 dB (at 85 dB/m)
Output (Level/Impedance) : 220 mV/ 2.2 kohm
General
Power Requirements :
230 V AC, 50 Hz (Europe)
120/230 V AC, 50-60 Hz (General Export)
Power Consumption : 6 W
Dimensions (W x H x D) : 435 X 87 X 294 mm
Weight (net) : 2.9 kg
Accessories :
AM Loop Antenna x 1, FM Antenna x 1
RCA pin plug cord x 1, Remote Control Cable x 1
● Improvements may result in specifications and
features changing without notice.
_ 15 _
Suggested remedy
Select "TUNER" in INPUT SELECTOR.
Adjust VOLUME accordingly.
Connect the terminal for system
connection correctly.
Connect the antenna on the rear panel.
Set the frequency correctly.
Install the antenna again after locating
the best reception position.
Turn off CD.
Select TUNER on the remote control.