Using The Machine - Stiga SP 375 Manual De Instrucciones

12
EN

7. USING THE MACHINE

IMPORTANT
Always remember that an
incorrectly used chain-saw may disturb others and
have a serious impact on the environment.
To respect people and the environment:
– Avoid using the machine in environments or at
times of the day when it may disturb others.
– Scrupulously comply with local regulations and
provisions for the disposal of waste materials
after sawing.
– Scrupulously comply with local regulations and
provisions for the disposal of oils, damaged
parts or any elements which have a strong im-
pact on the environment.
– A certain amount of chain lubricating oil is re le-
ased into the environment when the machine is
running, so only use biodegradable oils made
specifically for this use.
– To avoid the risk of fire, do not leave the ma-
chi ne with the engine hot on leaves or dry grass.
WARNING!
Always wear suitable clo-
thing when using the machine. Your dealer
can provide you with all the information on the
most suitable accident-prevention devices to
guarantee your safety. Wear anti-vibration
gloves. All the above-mentioned precautions
do not however guarantee the prevention of
certain risks – i.e. Raynaud's phenomenon or
Carpal tunnel syndrome. For operators who
use this machine for prolonged periods, it is
therefore recommended to have periodic
check-ups on the hands and fingers.
If any of the above mentioned symptoms
should appear, please contact a physician
immediately.
WARNING!
It takes specific training to
use the machine for felling and delimbing.
1. CHECKS DURING WORK
• Checking the chain tension
The chain tends to stretch gradually as you work,
so you need to check its tension frequently.
All manuals and user guides at all-guides.com
(or after replacing the chain), it must be checked
more frequently due to settling of the chain.
loose, as it can be hazardous if the chain slips
out of its guides.
To adjust the chain tension, follow the instructions
in Chapter 5.5.
• Checking the oil delivery
out lubrication! The oil tank may get almost empty
every time the fuel runs out. Make sure you top up
the oil tank every time you refuel the chain-saw.
chain are in place when you check the oil de-
livery.
Start the engine, keep it running at medium power
and check if the chain oil is delivered as shown in
the figure (Fig. 12).
You can adjust the chain oil flow using a screw-
driver on the adjuster screw (1 or 1a) of the oiler,
which is on the bottom of the machine (Fig. 12).
2. DIRECTIONS FOR USE AND CUTTING
Before felling or delimbing for the first time, prac-
tise sawing logs on the ground or on trestles, so
that you can get familiar with the machine and the
most suitable sawing techniques.
chine must always be firmly held in both
hands, with the left hand on the front handgrip
and the right hand on the rear handgrip, even
if the operator is left-handed.
USING THE MACHINE
IMPORTANT
During the first period of use
WARNING!
Never work with the chain
IMPORTANT
Never use the machine with-
WARNING!
Make sure the bar and the
TECHNIQUES
WARNING!
When running, the ma-