Operation - Bosch 0 275 U07 3SC Instrucciones De Servicio Originales

Requirements
The eBike system can only be activated when the fol-
lowing requirements are met:
– A sufficiently charged battery is inserted (see bat-
tery operating instructions).
– The speed sensor is connected properly (see drive
unit operating instructions).
Operating unit power supply (System
Controller)
If a sufficiently charged eBike battery is inserted into
the eBike and the eBike system is switched on, then
the control unit battery is powered and charged by
the eBike battery.
Please contact your bicycle dealer if the operating
unit battery is defective.
Operating unit (Mini Remote) power
supply
The Mini Remote operating unit is supplied with volt-
age by a CR1620 button/coin cell.
Replacing the battery (Mini Remote)
If the battery in the Mini Remote (1) operating unit is
low, the LED indicator lamp (3) lights up orange.
To replace the battery, unscrew the Mini Remote (1)
operating unit from the handlebars. Remove the rub-
ber insert (9). This also functions as the battery
holder. Remove the used battery and insert a new
CR1620 battery in the rubber insert (9). Push the
battery and the rubber insert (9) into the Mini Re-
mote (1) operating unit. If the battery is seated cor-
rectly, the LED indicator lamp (3) flashes green for
10 s. Then secure the Mini Remote (1) operating
unit back onto the handlebars.
Note: The connection to the System Controller is
not interrupted when the battery is replaced.
You can obtain the batteries recommended by Bosch
from your bicycle dealer.
Bosch eBike Systems

Operation

Switching the eBike system on/off
To switch on the eBike system, briefly press the on/
off button (12). After the start animation, the state of
charge of the battery is displayed in color with the
battery charge indicator (13) and the set assistance
level with the (10) display. The eBike is ready to ride.
The display brightness is controlled by the ambient
light sensor (11). Therefore, do not cover the ambi-
ent light sensor (11).
The drive is activated as soon as you start pedaling
(except at assistance level OFF). The motor output
depends on the settings of the assistance level.
As soon as you stop pedaling when in normal opera-
tion, or as soon as you have reached a speed of
20/28 mph, the eBike drive unit switches off the as-
sistance. The drive is automatically re-activated as
soon you start pedaling again and the speed is below
20/28 mph.
To switch off the eBike system, press the on/off but-
ton (12) briefly (< 3 s). The battery charge indica-
tor (13) and the assistance level LED (10) go out.
If no power is drawn from the eBike drive for
about 10 minutes (e.g. because the eBike is not mov-
ing) and no button is pressed on the on-board com-
puter or the control unit of the eBike, the eBike sys-
tem will switch off automatically.
Battery charge indicator
The battery charge indicator (13) displays the eBike
battery's state of charge. The state of charge of the
eBike battery can also be checked on the LEDs of the
battery itself.
In the (13) display, each ice-blue bar represents
20 % capacity and each white bar represents 10 %
capacity. The topmost bar shows the maximum ca-
pacity.
Example: Four ice-blue bars and one white bar are
displayed. The state of charge is between 81 % and
90 %.
English – 9
0 275 U07 3RC | (29.03.2022)