Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting of the glass holder
on round glass heater
1.3 - Intended
use
24
1. Place the glass holder on the edges opposite to each other.
2. Screw the glass holder directly to the rear wall by using the drilling
screws. Alternatively, you can also pre-drill (hole ø max. 2.8mm).
The
recommended
positions
Alternatively, both combinations are also possible (Glass holders can be
ordered separately as accessory set, see Accessories).
Improper
use
or
use
ger to the life and limb of the user or third parties or cause
damage
to
the
product
The product is used to increase the room temperature in closed residential
spaces.
Proper use includes:
– Observing the enclosed operating instructions for the product
and all other system components.
– Installation and assembly in accordance with the product and system
certification.
– Compliance with all inspection and maintenance conditions listed in
the manual.
Keeping children younger than 3 years of age away from the system,
unless they are constantly supervised.
Children above 3 years of age and younger than 8 may only switch the
product on/off if they are supervised or have been instructed in the
safe
use
of
the
product
ing
hazards
that
may
placed or installed in its normal position of use. Children above
3 years of age and younger than 8 must not insert the plug into
the power socket, adjust the product, clean the product nor should they
perform maintenance as the user of the product.
are
combinations
not
as
intended
may
and
other
material
and
fully
understand
occur,
assuming
that
A-A
or
B-B.
result
in
dan-
damages.
the
result-
the
product
is
Publicidad
Tabla de contenido
Solución de problemas
