Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING UP AN ARM
Choose an arm and prepare the locking pin (1). Put the arm with
care on the riveting machine nose, making sure that the 2 points of
reference are aligned.
For the implementation of large arms (eg, HR2, HR3), it is advisable
to lay the arms flat on a table and bring the nose of the riveting
machine in the arm's orifice.
For more details see the video:
As soon as the arm is on the riveting machine, push the
locking pin in the hole.
The axle locks itself automatically and must not be
allowed to become unlocked.
The locking pin must be clean with no damage. Do
not use any damaged pin.
Using the screw, fasten the extension
16
16
GYSPRESS 10T US
Maximum air pressure:
Make sure that the air pressure does not exceed 8 bar.
Clean compressed air:
Make sure you use only clean and dry compressed air for supply the riveting machine. Moisture
and impurities can lead to system failures and/or damages on the product.
supplied with the arm.
The riveting machine is now ready to use.
EN
Publicidad
