Technical Parameters; Method Of Use - UFESA Antares 1500 Manual De Instrucciones

se an electric shock, fire or damage the unit.
- Do not use the appliance to dry clothes.
- Do not use the heater in the immediate surroundings of a bath, a shower or a swimming pool.
- Do not use the heater if it has been dropped:
- Do not use is the is a visible sign of damage to the heater.
- Use this heater on a horizontal and stable surface or fix it to the wall, as applicable.
- Always use the device in an upright position.
- Unplug the unit whenever not in use. Do not pull the cord to unplug the appliance.
- Do not use the device if it is cracked or broken.
- Do not use the appliance in rooms with a surface less than 4m2.
- The appliance has a security system to be disconnected in case of accidental overheating.
To keep the unit working again unplug the power for a few minutes, check that has no object
obstructing the air inlet, let the device cool down and plug it back.
- Improper use of the product may involve danger and revoke the warranty and liability
Do not use, connect or disconnect the device to the network with wet hands and/or feet.
- Do not wrap the cord around the control button.
- WARNING: Do not use this heater in small rooms when they are occupied by persons not
capable of leaving the room on their own, unless constant supervision is provided.
- WARNING: to reduce the risk of fire, keep textiles, curtains, or any other flammable ma-
terial a minimum distance of 1 m from the air outlet.
B&B TRENDS SL accepts no liability for any damage that may be caused to people, animals
or objects owing to failure to observe this warning correctly.

TECHNICAL PARAMETERS

Model Specification
Antares 1500
Antares 2000
Antares 2500

METHOD OF USE

1. Open the packing box, take out the body and confirm whether the product is intact.
2. Before use, please make sure that the rated voltage of the power socket is 220-240V AC, the
rated current is greater than 15A and there is a reliable and safe grounding device.
3. The electrical oil heater can only be used after the casters are properly installed. Refer to
Caster Installation Method.
4. Method of using the type:(1) Rotate the thermostat clockwise to the top
(2) Turn on the power switch to start heating. If you need to heat up quickly, adjust the power
Voltage
7 fins 220-240 V
9 fins 220-240 V
11 fins 220-240 V
Frequency I
50-60 Hz 600 W
50-60 Hz 800 W
50-60 Hz 1000 W
II III
900 W 1500 W
1200 W 2000 W
1500 W 2500 W
21