When removing the appliance from the packaging, do not tilt the
appliance by more than 35°, as the built-in compressor might
otherwise be damaged. After unpacking the appliance, leave
the appliance at its final location for at least 2 hours before
putting it into operation. The refrigerant in the appliance needs
to settle first to keep the compressor from becoming damaged
The refrigerant is flammable.
In case of damage to the cooling circuit:
Avoid open flames and sources of ignition.
Thoroughly ventilate the room where the appliance is located.
Never open the motor housing of the appliance – risk of electric
shock!
Never cover the appliance during operation!
Do not hang the exhaust hose out of the window when it rains to
keep water from penetrating the appliance.
BEFORE FIRST USE
1.
Remove all packaging and transport safety devices. Keep packaging
materials out of the reach of children – danger of suffocation! Dispose of
the packaging material according to the applicable statutory waste disposal
regulations.
2.
Inspect the appliance for damage. If there is visible damage, do not operate
the appliance; instead, contact our customer service department.
3.
Check whether all accessories listed in this manual have been shipped with
your appliance.
4.
Make sure that the cover cap of the water drain on the rear of the appliance
has been tightened firmly.
5.
When the appliance is used for the first time, and after prolonged storage,
there might be some minor odour.
Stand 9.8.2022
DE
EN
FR
NL
IT
ES
PL
37 von 152