Remote Control - Unold ARCTIC 7k Instrucciones De Uso

DE
6. Spread out the sealing film and hold it up in front of the window with the
curved side facing you. Attach the film next, making sure that the middle of
EN
the sealing film is level with the middle of the window.
7. Proceed by connecting the hook-and-loop parts of the sealing film with the
FR
hook-and-loop tape on window sash and window frame. The curved portion
NL
of the sealing film needs to be connected to the hook-and-loop tape on the
window frame, while the straight portion of the sealing film must be joined
IT
with the hook-and-loop tape on the window sash.
8. Close the window and check if the sealing film is properly seated. Correct
ES
as needed.
PL
9. Open the window again and pull down the zip fastener far enough for the
exhaust hose to be slipped through. Pull the zip fastener up again and make
sure that the hose is seated firmly and cannot slip out.
10. When the air conditioner is not in used, remove the hose from the zip
fastener, which will allow you to close the window normally. Another option
is to remove the sealing film and to re-apply when using the air conditioner
again.

REMOTE CONTROL

1. Prior to initial use, you must pull the small plastic film out of the battery
compartment.
2. Carefully release the clip of the cover on the battery compartment and pull
the cover off the remove control.
3. Place the battery into the designated holder.
4. If you wish to insert another battery, make sure to use a CR2025 coin
battery.
5. Slide the cover carefully back into the remote control.
6. If the appliance is not used for an extended period, please remove the
battery.
7. When setting up the appliance with the remote control, make sure to point
the remote at the air conditioner while adjusting the settings. The remote
control has a range of approx. 5 metres.
8. The individual functions are represented by the following symbols:
40 von 152 Stand 9.8.2022