Important; After Treatment - HoMedics Refresh FAC-HY100-EU Manual De Instrucciones

Press the tip against the skin and immediately
start to move it in a slow gliding motion
following the contours of your face.
NOTE: After creating a seal against the skin it
can initially take up to 8s for the device to prime
before the water starts flowing.

IMPORTANT

• Keep the device constantly moving. Stopping in one spot for too long can cause
bruising.
• Do only one pass per area per treatment.
• Pull skin taut for a smoother pass.
As treatment continues the 'clean water' side of the tank will empty and 'dirty water' will
collect in the other side. Once the clean water side is empty, switch off the device.

AFTER TREATMENT

• Turn off the device by pressing the power button.
• Remove the water tank, empty it, and run a cleaning cycle as described below.
• Wash the cleansing tips and in warm soapy water, rinse well and allow to dry.
• Wash your face with cold water to remove any remaining dead skin cells and then apply
your preferred moisturiser.
• NOTE: Avoid using AHA (acid based) moisturisers on the day of treatment
• Depending on your skin type, you may experience some reddening or increased
sensitivity after treatment. This is perfectly normal and usually subsides within a few
hours.
• Avoid direct sun exposure after treatment, consider applying a stronger sunscreen as
required.
Power button
STEP 6
GB
I
STEP 5
Turn on the device by pressing the
power button.
The LED will light white.
4