Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MOBILE
PIEDINO
Adjustable foot
After adjustment, to avoid their modification by
vibrations, they should tighten by the nut on the
foot until it locks as shown in the figure below.
DADO
Nut
It is good to avoid, in any case, placing under
or around to the machine cardboard, wood
or similar materials, so as not to obstruct the
passage of air.
INsTALLATION UNDEr A WOrK pLAIN
The positioning of the machine under a
work plan, can only happen if the housing
compartment has the following dimensions of
width of 76 cm and of height of 85 cm. It should
also be considered that the machine needs a
approximately 5 cm behind from the wall. An
example of a typical installation is shown in the
illustration below. The superior cover (TOP) of
the machine must not be removed for reasons
of electrical and mechanical safety.
85 cm
39601005005 - Mutilingua Pittogrammi.indb 11
Figure 3a
Cabinet
Figure 3b
Figure 4
LEVEL
76 cm
WATEr sUppLY CONNECTION
The water inlet hose must be connected to a
tap of cold water with a 3/4" threaded mouth.
Use only the supplied water inlet hose. Avoid
the use of old hoses or hoses used previously.
N.b. The hose is already complete with
rubber gasket, if this is missing, the tube
must not be used.
If the water supply system is new or has been
inactive for too long, it will be necessary to allow
the water run until the it appears clear.
Figure 5
Figure 5b shows the connection to the hot water
tap, this option is only available on request.
Figure 5b
Make sure that the domestic hot water supply
temperature does not exceed 55°C to avoid
damage to the laundry and washing machine.
For the inlet hose only use the supplied.
EN
11
06/07/2018 17.43.44
Publicidad
Tabla de contenido
