Water Drainage; First Use; Power Supply Connection - sangiorgio F814CD Manual De Operación Y Mantenimiento

WATEr DrAINAGE

Drain hose can be installed in two different
ways:
- On the edge of sink using the plastic hose
hanger commercially available.
In this case make sure that the tube is secured
to the sink.
- In a drain pipe at a height of not less than
60 cm and not more than 90cm.
The tube end must always be ventilated, i.e. the
inside diameter of the drain pipe must be larger
than the outer diameter of the drain hose of the
washing machine. The drain hose must not be
obstructed.
Example of installation
Max 90 cm
Min 60 cm
N.b. It is not recommend using extension
on the drain hose.
LIQUID DETErGENT bULKHEAD pAN
Inside the kit supplied, there is a bulkhead pan
of blue colour which grants the use of liquid
detergents in the washing machine.
To install a bulkhead it is necessary to:
• remove the detergent drawer from the
washing machine
• apply the bulkhead as shown in photo
(see figure 7)
12
39601005005 - Mutilingua Pittogrammi.indb 12
Figure 6
Figure 7
1
After installation, replace the drawer into the
washing machine. There is no need to remove
the bulkhead (see p. 22).

FIrsT UsE

before the normal washing op-
eration a wash cycle of with
the cotton programme at 80°C
must be run with detergent and
without laundry.

power supply connection

The machine is equipped with a connect-
ing cable and earthed schuko plug for
connection to AC 230 V ~ 50 Hz.
Make sure the schuko plug is always ac-
cessible to unplug the machine from the
mains. The electrical power system must
be designed according to VDE 0100. It is
recommend not to connect, in any case,
the machine with extension cords, multi-
ple power sockets, etc to avoid overheat-
2
06/07/2018 17.43.50