Motion Sensor; Troubleshooting Guide - Good Earth Lighting SE1216-BRS-02LF4-G Manual De Instrucciones

The light turns on when the motion sensor detects movement. Sensor
detects motion up to 40 ft. The 180-degree coverage of the motion
sensor is measured side-to-side. The sensor is more e ective
side-to-side, rather than motion coming straight at it
(in-and-out). Fixed timer is 15 seconds; the light will stay on
for 15 seconds after motion detection (only during night
hours).
Extreme hot or cold weather could a ect the performance of the built-in
sensors that detect body heat. Certain winter clothing can shield a person's
body heat from the sensor during extreme cold weather. During extreme hot
weather, the sensor may not be able to distinguish the di erence between
normal body temperatures and the surrounding high temperatures. The
sensor works as expected once weather conditions return to normal.
PROBLEM
Security light
1. ON/OFF switch is not set correctly.
does not come
2. Batteries are defective or depleted.
on.
3. Batteries are installed wrong.
4. Battery compartment cover is loose.
5. Movement is taking place outside of
the motion sensor detection area.
Light
1. Light sensor is triggered by reflected
continuously
light from the security light itself.
cycles ON and
2. Heat is being reflected from other
OFF (strobe
sources and may be triggering the
e ect).
sensor on and o .
Light turns on
1. Light may be installed in shadows/dark
during daylight
area.
hours.
Light comes on 1. Hot air (dryer vent, car exhaust, etc.)
may be triggering the sensor.
for no apparent
reason.
1. Motion sensor may be picking up a
Light stays on
continuous flow of warm air from an air
continuously at
vent, dryer vent, or heat reflecting o a
night.
surface.
REPLACEMENT PARTS LIST: Hardware Kit: ZH-SE1216F02
Need Help?
Good Earth Lighting
Good Earth Lighting
6

Motion Sensor

Troubleshooting Guide

POSSIBLE CAUSE
Please visit our website at: https://goodearthlighting.com/contact-us or call the Customer Care Center
1-800-291-8838, 8:30 a.m.-5 p.m., CST, Monday-Friday.
1400 East Business Center Drive, Ste. 108 Mount Prospect, IL 60056
®
is a registered trademark of Good Earth Lighting, Inc. © 2022 Good Earth Lighting, Inc. REV07.22
®
CORRECTIVE ACTION
1. Slide switch to "ON" position.
2. Replace the batteries.
3. Reinstall the batteries correctly.
4. Check battery compartment cover to ensure it is closed
and secured with the screw.
5. Fixture detects motion up to 40 ft. Make sure it is
positioned within that range.
1. Change the position of the light heads, aiming light
away from the reflecting surfaces.
2. Remove heat source from detection zone or move
fixture to new location.
1. Move fixture to a lit area; without shadows.
1. Remove heat source from detection zone or move
fixture to new location.
1. Remove heat source from detection zone.
Move fixture to new location.
Reposition the motion sensor.
180°
Printed in China