Installation Warnings - universalblue UBH2301-21 Manual De Instrucciones

INSTALLATION WARNINGS

The dimensions and materials of the cabinet or cabinet in which the
built-in oven will be installed must be correct and must be resistant
to temperatura increases. Install as shown in the Figure.
The walls of the furniture in which the oven is installed must be
resistant to heat. The wall panels must be resistant to 100 ° C,
especially if the side walls are made of wallboard. Plastic panels or
adhesives that are not resistant to this heat can be deformed and
damaged.
 For safety reasons, direct contact with the electric oven parts
should be avoided.
 The insulation and protection parts must be installed in such
a way that they can not be removed with any tool.
 The oven must be installed as in the Figure to provide a more
effective air flow.
 It is recommended to leave a space of at least 40 mm in the
back of the kitchen unit in which the oven is installed.
 A support must be placed under the oven that can support
the weight when placing the oven.
 The rear section of the cab in the kitchen unit should be re-
routed to provide a better fl ow of air.
 It is not recommended to install the device near refrigerators
or freezers, otherwise the performance of these devices
would be affected by the radiated heat.
 Place the device centered in the inlaid cabin
 Open the oven lid and mount the body on the countertop with
four thumbscrews aligning the holes on the sides.
 The oven can be mounted in a cabinet above or below the
counter, if desired

When mounting a built-in electric stove on the countertop
above the oven, the electricity cords of the oven and the
stove must be separated to remove the oven from the stove
when necessary
.
43