MADER ABW-VAN-90P Manual Del Usuario página 51

WARNING!
This machine
not suitable for connection to
the potable water mains.
WARNING!
The machine is intended to be
used at a temperature above o degree. (Only
for machine with power cord of H05VV-F).
WARNING!
To ensure the machine safety,
please only use original spare parts (including
nozzle) from the manufacturer or approved by
the manufacturer. Do not use the machine
before you changed them if they are damaged.
WARNING!
Be care of the danger of the
kickback force on the spray assembly when
opening the trigger gun and grasp the gun with
hands firmly.
WARNING!
When the machine is moving
and installing, the machine must be in flat.
When moving the machine, pulling the handle
to move it.
WARNING!
Connect to the water supply.
The machines are not suitable for connection
to potable water mains.
Connect the machine to the water supply. (It
can be a water container).
Make sure the inlet water pressure keeps
between 0.01MPa and 0.4MPa.
The inlet pipe should at least 5 M long. Do not
use the pipe if the pipe is damaged.
If you want to connect this machine to portable
water mains, you must install a backflow
preventer in the water pipe to prevent dirty
water flow back to the drinking water system.
The backflow preventer shall comply with EN
60335-2-79 ANNEX AA.
WARNING!
power supply before carrying out user
maintenance.
If the mains cable is damaged it must be
replaced by the manufacturer, or its service
agent or similarly qualified person to avoid a
hazard.
CONNECTION
1. Attach the high-pressure hose to the
pressure water outlet of the machine.
2. Attach the spray handle to the high-pressure
hose. Prior to operating the machine please
ensure that the high-pressure hose has been
completely uncoiled. Whilst the machine is in
operation the hose MUST not loop.
3. Mount the nozzle or any other equipment
you want to use.
4. Connect the machine to the water and
power supplies.
49
Disconnect from the electrical