Final Rinse - MADER ABW-VAN-90P Manual Del Usuario

UNITS WITH DETERGENT APPLICATOR
INCLUDED
Follow manufacturer's label directions for
mixing correct concentrations of detergent to
water ratio through the pressure washer is
approximately 5.4% (1 to 19).
1. Unscrew to top of detergent applicator and
fill applicator with detergent.
2. Replace top on applicator.
3. Remove lance from gun.
4. Attach detergent applicator to gun. (See
Figure 8)
5. Apply detergent so it thoroughly covers
cleaning surface. Apply from bottom to top to
prevent detergent from sliding down and
streaking.
6. Allow detergent to remain on the surface for
a few minutes. This is a good time to use a
brush to lightly scrub heavily soiled areas.
Never allow detergent to dry on the cleaning
surface.
7. Remove detergent applicator from gun and
replace with the lance or remove applicator
from end of lance.
8. Rinse detergent from surface.
NOTE:
Flush detergent applicator with clear
water following each use.
4. F R
INAL INSE
start final rinse at bottom and work upward.
Make sure you thoroughly rinse the surface
and that all detergent has been removed.
5. S
HUT DOWN
1. Be sure all detergent is flushed from system.
2. Turn off motor.
3. Turn off water supply.
4. After motor and water supply are turned off,
trigger gun to depressurize system.
CAUTION:
before turning motor off. Serious damage could
occur to the pump and or motor.
WARNING!
pressure discharge hose from machine while
system is pressurized. To depressurize, turn
motor off, turn water supply off and squeeze
54
NEVER turn water supply off
NEVER disconnect high