Pre-Operation - MADER ABW-VAN-90P Manual Del Usuario

I , E
NSTALLATION
W C
ATER ONNECTIONS
1. pressure cleaner
3. water connection
5. high pressure tube 6. water outlet
7. spray gun
* No. 2, 3, 8 are not included

PRE-OPERATION

A F
DJUSTING AN
The angle of spray coming out of the lance may
be adjusted on some lances by rotating the
nozzle. This will vary the spray pattern from
approximately a 0° narrow high impact stream
to a 60° wide fan spray. (See Figure2)
A narrow stream has high impact force on
A
LECTRICAL ND
2. water supply hose
4. water inlet
8. power supply
P
ATTERN
the cleaning surface and results in maximum
deep cleaning in a concentrated area. However,
this narrow high impact spray must be used
cautiously, as it may damage some surfaces.
A wide fan pattern will distribute the impact of
the water over a larger area, resulting in
excellent cleaning action with a reduced risk of
surface damage, Large surface areas can be
cleaned more quickly using a wide fan pattern.
N C
OZZLE LEANING
A clogged or partially clogged nozzle can cause
a significant reduction of water coming out of
the nozzle and cause the unit to pulsate while
spraying. To clean out the nozzle:
• Turn off and unplug unit.
• Turn off water supply. Relieve any pressure
trapped in the hose by squeezing
50
I
NSTRUCTIONS